Creality V2 2 Board Diagram [new] Direct

The (also referred to as the V2.2 Silent Board) is an 8-bit control board based on the Atmel ATmega2560 processor. Primarily found in larger machines like the CR-10S, CR-10 S5, CR-X, and Ender-5 Plus , it was a standard upgrade over older V1.x boards by integrating silent stepper drivers and a native bootloader. Key Technical Specifications Processor: Atmel ATmega2560 (8-bit).

The V2.2 board is frequently used for BL-Touch / CR-Touch upgrades. Note that wiring can vary by cable manufacturer: Creality V2 2 Board Diagram

The board features four integrated A4988 drivers (non-removable). You’ll see four 4-pin JST-XH connectors labeled: For horizontal movement. The (also referred to as the V2

(If the image does not load, please refer to the text pinout below or the official Creality GitHub repository). The V2

| Endstop | MCU Pin | Internal Pullup | |---------|---------|----------------| | X‑min | PA1 | Yes (10k) | | Y‑min | PA0 | Yes | | Z‑min | PC14 | Yes |

via a ribbon cable. Most auxiliary components (fans, sensors, leveling probes) plug into this breakout board rather than the mainboard directly. Calibration: The "Paper Test"

The , often referred to as the V2.2.1 "Silent" motherboard, is a legendary 8-bit upgrade originally designed for the Creality CR-10S series and later utilized in printers like the Ender 5 Plus. Unlike the newer 32-bit V4.2.2 boards found in the Ender 3 V2 , the V2.2 uses an Atmega 2560 processor and is prized for its reliability in dual-extrusion or dual-Z axis setups. Understanding the V2.2 Board Layout