Makerbase Mks Dlc V21 Manual Link __link__ < Trusted >

For community support and troubleshooting, users often frequent the LightBurn Software Forum or the FluidNC Wiki .

Use the $I command in the console to check your current firmware version and $$ to view/edit your machine parameters (steps per mm, max speed, etc.). makerbase mks dlc v21 manual link

: Most boards support mechanical switches (GND and S) or optical sensors (requires 5V). For community support and troubleshooting

For Lasers: Use the TTL/PWM port (usually 12V or 5V depending on your module). For Spindles: Connect to the spindle relay control pins. makerbase mks dlc v21 manual link

: The TTL/PWM signal typically uses the "Laser" or "Spindle" port depending on your firmware configuration.

: Detailed circuit diagrams are available at GitHub.

Shared ground-triggered MOSFET output for controlling laser modules or CNC spindles. Setup & Firmware Installation